Regulation compliance

Working at height for heating engineers: lofts and flues

How heating engineers apply the Work at Height Regulations to loft boilers, flue terminals and roofs: avoid, prevent, minimise, with a planning checklist.

Ava research teamPublished 7 min read

On this page
  1. Falls are still the biggest killer
  2. The hierarchy in regulation 6
  3. Lofts: the job you do most
  4. Ladders and stepladders
  5. Flues, chimneys and roofs
  6. Planning a job at height
  7. Equipment checks and records
  8. Example: a loft boiler replacement
  9. Alone at height
  10. Frequently asked questions
  11. References

Key takeaways

  • Falls from height were the most common cause of worker deaths in Great Britain in 2025/26, killing 31 of 126 workers[1].
  • The law sets a clear order: avoid work at height where reasonably practicable, prevent falls with a safe place or equipment, then minimise distance and consequences[2].
  • Falls from height were also 8% of non-fatal injuries to employees reported in 2024/25[3].
  • Loft boilers and roof-mounted flue terminals are where heating engineers most often work at height, and both can be planned.

Falls are still the biggest killer

HSE's provisional figures for 2025/26 show 126 workers killed in work-related accidents in Great Britain, with 25 of them in construction[1]. The single most common kind of fatal accident was a fall from height, which killed 31 workers[1]. Behind each figure are the same few situations: a ladder that slipped, a fragile roof, an open hatch, a platform without an edge.

Workers killed in work-related accidents in Great Britain by kind of accident, 2025/26Provisional figures, to be finalised in 2027.
Workers killed in work-related accidents in Great Britain by kind of accident, 2025/26Bar chart. Falls from a height: 31 deaths; Struck by moving vehicle: 24 deaths; Struck by moving object: 21 deaths; Trapped by something collapsing or overturning: 18 deaths; Contact with moving machinery: 10 deaths.Falls from a heightFalls from a height: 31 deaths31 deathsStruck by moving vehicleStruck by moving vehicle: 24 deaths24 deathsStruck by moving objectStruck by moving object: 21 deaths21 deathsTrapped by something collapsing or overturningTrapped by something collapsing or overturning: 18 deaths18 deathsContact with moving machineryContact with moving machinery: 10 deaths10 deathsWorkers killed in work-related accidents in Great Britain by kind of accident, 2025/26Bar chart. Falls from a height: 31 deaths; Struck by moving vehicle: 24 deaths; Struck by moving object: 21 deaths; Trapped by something collapsing or overturning: 18 deaths; Contact with moving machinery: 10 deaths.Falls from a heightFalls from a height: 31 deaths31 deathsStruck by moving vehicleStruck by moving vehicle: 24 deaths24 deathsStruck by moving objectStruck by moving object: 21 deaths21 deathsTrapped by something collapsing oroverturningTrapped by something collapsing or overturning: 18 deaths18 deathsContact with moving machineryContact with moving machinery: 10 deaths10 deaths

Source: Health and Safety Executive, 2026[1]

Show the data
ItemValue
Falls from a height31 deaths
Struck by moving vehicle24 deaths
Struck by moving object21 deaths
Trapped by something collapsing or overturning18 deaths
Contact with moving machinery10 deaths

Falls cause many more injuries than deaths. Among non-fatal injuries to employees reported under RIDDOR in 2024/25, falls from height made up 8%[3]. Heating engineers rarely work on high scaffolds, but they spend a lot of time in lofts, on stepladders in airing cupboards and occasionally on roofs to reach flue terminals and chimneys. The distances are short, and that is exactly why the risk gets underestimated.

The trade is large enough for these risks to matter at scale. Great Britain's plumbing, heat and air-conditioning installation industry had 176,000 employees in 2024[4], and every one of them will climb into a loft or onto a ladder at some point in the year.

The hierarchy in regulation 6

The Work at Height Regulations 2005 set out an order of thinking that applies to every job. Regulation 6 requires employers to take account of a risk assessment made under the Management of Health and Safety at Work Regulations, then work through the following steps[2].

  1. Avoid work at height where it is reasonably practicable to do the work safely another way.
  2. Where work at height cannot be avoided, take suitable and sufficient measures to prevent anyone falling a distance liable to cause injury, preferably by working from an existing place of work that is safe, otherwise by providing work equipment that prevents a fall.
  3. Where the risk of a fall remains, provide work equipment to minimise the distance and consequences of a fall, plus additional training, instruction or other measures.

Those steps come straight from regulation 6[2]. In plain terms: do it from the ground if you can, make the place safe if you cannot, and if a fall is still possible, make it shorter and softer. If you are self-employed, the same order of thinking is the sensible way to plan your own work.

Lofts: the job you do most

Common loft hazards on heating jobs and controls that follow the avoid, prevent, minimise order.
Loft hazardWhat can go wrongControl
Open hatchStepping backwards into the opening, or a second person climbing up into youGuard rail or hatch cover; agree who goes up and down when
Unboarded joistsFoot through the ceiling, fall between joistsBoarded walkway to the work area and around the appliance
Poor lightingMisjudging footing and headroomFixed lighting, plus task lighting for the work
Loose or temporary ladderLadder slips or moves while you climb with toolsFixed loft ladder, or a secured ladder with the top extending above the hatch
Carrying loadsLosing balance while carrying a boiler or cylinder up the ladderLift loads separately with a second person or lifting aid
Heat and confined spaceFatigue, dehydration and poor decisionsPlan breaks, ventilate, work in cooler hours on hot days

Most boiler manufacturers set out access requirements for loft installations in their instructions, typically covering a fixed ladder, boarding, lighting and a guard around the hatch. Read them before you quote. If the loft does not meet them, the access works are part of the job, not an optional extra, and the customer should see them priced as such.

Where a customer wants a boiler moved out of the loft, take the opportunity. Avoiding the work at height altogether, by siting the appliance somewhere reachable from the floor, is the first step in the hierarchy and makes every future service safer.

Ladders and stepladders

Ladders are not banned. They are reasonable for short, low-risk tasks where a better option is not practicable, but they offer no protection if you lose your footing. A sensible firm policy covers the following points:

  • Use ladders and stepladders only for short jobs that need little force and can be done with one hand free.
  • Inspect each ladder before use and take damaged ones out of service immediately.
  • Secure leaning ladders, keep three points of contact while climbing and never overreach.
  • Use a podium step or platform instead of a stepladder for longer jobs, such as working on a cylinder in an airing cupboard.
  • Never use a ladder on a roof slope or to step onto a roof.

Flues, chimneys and roofs

Roof work is where heating engineers face the greatest fall distances. Vertical flue terminals, chimney liners and roof-mounted cowls often need access to the roof itself. That work should be planned like any other roof work: scaffold with edge protection, a tower or a mobile elevating work platform, chosen for the building and ground conditions. A ladder to the gutter followed by a scramble up the slates fails the second step of the hierarchy.

Watch for fragile surfaces. Rooflights, old asbestos cement sheets on garages and lean-tos, and corroded metal sheets can give way without warning. If a flue passes through a garage or outbuilding roof, treat the roof as fragile until you know otherwise, and keep off it.

Where possible, design the work at height out at quote stage. A horizontal flue through a side wall may avoid roof access entirely, and some terminals can be installed and inspected from inside the building. Those choices also matter for every future service visit.

Planning a job at height

  1. Ask at booking

    Where is the appliance? Is there a fixed loft ladder, boarding and lighting? Does the flue terminate on the roof?

  2. Decide the access

    Choose the method that best follows the hierarchy for this job, and price it into the quote.

  3. Brief the team

    Make sure everyone knows the access plan, who goes up first and how loads will be lifted.

  4. Check equipment

    Inspect ladders, towers and harnesses before use, and keep a simple record.

  5. Plan for rescue

    Know how you would get someone down if they were injured or became ill at height.

  6. Review after the job

    Note anything that would make the next visit safer, such as adding boarding or a guard rail, and offer it to the customer.

Equipment checks and records

Access equipment wears out in vans faster than anywhere else. Ladders slide around, feet wear down and stiles get dented against tool boxes. A short pre-use check catches most problems: feet present and sound, stiles straight and undamaged, rungs or treads secure and clean, locking bars working on stepladders. Anything doubtful is taken out of use and labelled so nobody picks it up by mistake.

Add a more detailed check at set intervals, for example monthly, and write it down with the date and the name of the person who checked. Towers and platforms need inspection after assembly and before use in a new position. The record does not need to be elaborate; a page in the van or a note in your job app is enough, provided it is kept up.

Training matters as much as the kit. Make sure everyone who uses a tower or podium knows how to assemble it and when it is not suitable, and that apprentices are shown how to set up and climb a ladder properly rather than left to copy whoever they work with.

Example: a loft boiler replacement

Example: a two-person heating firm in Bath is asked to replace a loft-mounted combination boiler. At survey the engineer finds a push-up hatch, no fixed ladder, two boards near the boiler and a single bulb. The manufacturer's instructions for the new boiler require permanent safe access. The quote includes a fixed loft ladder, boarding from the hatch to the boiler, a light switched at the hatch and a guard rail.

On the day, the access works are fitted first. The old boiler is lowered on a rope with one person in the loft and one on the landing, and the new boiler is raised the same way. The customer later says the new ladder and boarding were worth it for the storage alone. The firm records the access arrangements on the job sheet, so whoever services the boiler next year knows what to expect.

Alone at height

Many heating engineers work alone, and a fall in an empty house can leave someone undiscovered for hours. For any work at height when working alone, agree a check-in routine with the office, avoid roof work entirely, and keep a phone on you rather than in the van. If the job needs two people to be safe, it needs two people, whatever the schedule says.

A short question saves most falls: could this be done from the floor, or from a platform instead of a ladder? Ask it at quote stage, not at the top of the ladder.

Frequently asked questions

Can heating engineers still use ladders?

Yes, for short, low-risk tasks where a safer option is not reasonably practicable. For longer jobs, platforms, towers or other equipment that prevent falls should be used instead.

What does the Work at Height hierarchy mean?

Avoid working at height where you reasonably can, prevent falls with a safe place of work or suitable equipment, and where a fall is still possible, minimise the distance and consequences.

Does a loft boiler need permanent access?

Most boiler manufacturers specify safe permanent access for loft installations, typically a fixed ladder, boarding, lighting and a guard around the hatch. Check the instructions for the boiler you are fitting.

How many workers die from falls from height each year?

HSE's provisional figures for 2025/26 show 31 worker deaths from falls from height in Great Britain, the most common kind of fatal accident.

References

  1. Health and Safety Executive (2026). Work-related fatal injuries in Great Britain (opens in a new tab) ↑

  2. legislation.gov.uk (The National Archives) (2005). The Work at Height Regulations 2005, regulation 6 (opens in a new tab) ↑

  3. Health and Safety Executive (2025). Non-fatal injuries at work in Great Britain (opens in a new tab) ↑

  4. Office for National Statistics (Nomis) (2024). Business Register and Employment Survey: open access (SIC 2007 class 43.22), via Nomis (opens in a new tab) ↑

Book a demo

See Ava handle your calls.

Book a short demo. We’ll walk through your calls and workflow, and agree what Ava should take care of.

Book a demo