Seasonal operations

Winterising empty properties and holiday lets

Keep warm, drain down or both? Winterising empty homes and holiday lets: frost settings, drain-down steps, insurer conditions and a safe restart.

Ava research teamPublished 7 min read

On this page
  1. Why empty homes are the ones that flood
  2. Keep warm, drain down, or both?
  3. Frost protection settings
  4. Drain-down step by step
  5. What to ask about insurance
  6. Bringing the property back into use
  7. Rented homes between tenants
  8. Holiday lets and second homes
  9. Check visits while the property is empty
  10. Example: a probate property
  11. Related reading
  12. Frequently asked questions
  13. References

Key takeaways

  • Decide per property whether to keep the heating on frost protection, drain the system down, or do both for different parts of the system.
  • Read the owner's insurance wording before you start; unoccupancy conditions often decide the method.
  • Private rented homes are less likely to have central heating[1] and more likely to fail the Decent Homes Standard[2], so voids need extra care.
  • When a property has been empty, flush outlets or drain the system so water does not stagnate[3], and recommission properly before anyone moves back in.
  • Leave a written record at the property and send one to the owner: what was done, what is off and how to restart.

Why empty homes are the ones that flood

A burst pipe in an occupied home is caught within minutes. In an empty home it can run for days. Holiday lets between bookings, homes waiting for probate, rentals between tenants and second homes left for the winter all share the same risk: no heat, nobody watching and a water supply that is still on.

Rented homes need particular care. Only 85% of private rented homes in England had central heating in 2024, against 95% of owner-occupied and local authority homes[1], and 22% of private rented homes failed the Decent Homes Standard, the highest of any tenure[2]. Older systems, partial heating and poor insulation are all more common in the homes most likely to sit empty between lets.

Homes in England with central heating, by tenure, 2024
Homes in England with central heating, by tenure, 2024Comparison. Private rented: 85%; Owner-occupied and local authority: 95%.85%Private rentedPrivate rented: 85%95%Owner-occupied and local authorityOwner-occupied and local authority: 95%Homes in England with central heating, by tenure, 2024Comparison. Private rented: 85%; Owner-occupied and local authority: 95%.85%Private rentedPrivate rented: 85%95%Owner-occupied and local authorityOwner-occupied and local authority: 95%

Source: Ministry of Housing, Communities and Local Government (GOV.UK), 2024[1]

Show the data
ItemValue
Private rented85%
Owner-occupied and local authority95%

Keep warm, drain down, or both?

There is no single right answer. The choice depends on how long the property will be empty, whether someone can check it, the heating system and what the owner's insurance requires.

Choosing a winterising method for an empty property
MethodSuitsAdvantagesDrawbacks
Heating on frost protection, water onShort gaps, regular visits, reliable boilerQuick to restart; protects the building fabricRelies on the boiler and power staying on; a burst still floods
Water off at the stop tap, heating on lowGaps of a few weeks with a working boiler on a sealed systemLimits flood damage; keeps the property dryCheck the boiler can run safely with the mains off; hot water outlets unusable
Full drain-downLong voids, no visits, unreliable heatingNothing left to freeze or burstTakes time; needs proper refill and recommissioning; legionella and corrosion risks on restart
Partial drain-downOutbuildings, annexes, outside tapsProtects the most exposed partsMust be clearly labelled so nobody refills by mistake

In many cases a combination works best: heating left on a frost setting, outside taps isolated and drained, and the incoming main turned off at the stop tap if the system can run without it. Whatever you choose, write it down for the owner.

Frost protection settings

If the heating stays on, set it to protect the building rather than to heat it. Most modern boilers have a built-in frost function, but that only protects the boiler itself, not pipes in the loft or under the floor.

  • Set the room thermostat or smart control to a low frost setting, and check the boiler's own frost protection is enabled.
  • Fit a frost thermostat or pipe thermostat where pipes run through cold spaces, if the system has none.
  • Set radiator valves to their frost position rather than fully off, so heat reaches every room.
  • Leave internal doors and the loft hatch open so warmth circulates.
  • Check the boiler pressure and leave a note of the correct reading for anyone who visits.
  • Make sure the electricity supply will stay on; a prepayment meter that runs out turns the whole plan off.

Drain-down step by step

  1. Agree it in writing

    Confirm with the owner which parts will be drained and that they understand the property will have no water or heating until recommissioned.

  2. Isolate

    Turn off the boiler and its electrical supply, then the incoming water at the stop tap. Isolate any cold water storage tank.

  3. Drain hot and cold

    Open taps, starting upstairs, and drain the cold and hot water services from the lowest drain points. Drain the cylinder if there is one, following the manufacturer's instructions for unvented cylinders.

  4. Drain the heating

    Drain the heating circuit through the lowest drain-off, opening bleed valves to let air in. Do not forget toilets, cisterns, showers, appliances and outside taps.

  5. Protect what cannot drain

    Traps and pumps may hold water. Follow manufacturers' guidance for anything that cannot be fully drained.

  6. Label and record

    Label the stop tap, boiler and consumer unit: system drained, do not refill without an engineer. Leave a dated record at the property and send a copy to the owner.

What to ask about insurance

Most home insurance policies have conditions for unoccupied properties, and they differ between insurers. The owner should check the wording, but you can help by asking the right questions before you choose a method.

  • After how many days does the policy treat the home as unoccupied?
  • Does it require the water to be turned off, the system drained, or the heating kept on at a minimum temperature?
  • Does it require regular inspections, and how often?
  • Is escape of water cover reduced or excluded while the property is empty?
  • Does the insurer need to be told about the vacancy?

Record which conditions the owner told you about and how your work meets them. If there is a claim later, that record helps the owner show they met the policy terms.

Bringing the property back into use

Restarting is where problems appear: air locks, seized pumps, weeping joints and stagnant water. The Health and Safety Executive advises landlords that outlets should be used at least weekly to keep water moving, and that for long vacancies a suitable flushing regime or measures such as draining the system should be put in place so water does not stagnate[3].

  1. Refill slowly with taps part-open, checking every joint and appliance for leaks.
  2. Vent radiators and check system pressure; top up inhibitor if the heating circuit was drained.
  3. Recommission the boiler and check it is operating safely before the property is handed back.
  4. Run every hot and cold outlet, including showers, until the water runs clear and at temperature.
  5. Check the cylinder reaches its normal storage temperature before anyone uses it.
  6. Leave a note confirming the property is back in normal use.

Rented homes between tenants

For landlords, a void is a good time for the annual gas safety check. Landlords must have each gas appliance and flue checked at intervals of no more than 12 months[4] and give existing tenants a copy of the record within 28 days of the check[5], or new tenants before they move in. Doing the check during a void, once the system is recommissioned, avoids access problems and means the record is ready for the new tenant.

Holiday lets and second homes

Holiday lets sit empty in short gaps all winter, so a full drain-down is rarely practical. Remote controls help: a smart thermostat lets the owner confirm the heating is running, a leak sensor under the boiler and sink sends an alert, and an automatic shut-off valve can close the main when a leak is detected. Recommend these as a package, with a frost setting and isolated outside taps, and offer a check visit after any prolonged freeze.

Check visits while the property is empty

If the heating stays on, someone should look in regularly, and after any prolonged freeze. Offer owners a short check visit with a fixed list, or give the person who does look in a card to follow. The visit takes fifteen minutes and catches most problems before they become claims.

  • Is the heating running and the boiler pressure normal?
  • Any water marks on ceilings, under sinks or around the boiler and cylinder?
  • Is the electricity on and, for prepayment meters, is there credit?
  • Are outside taps still isolated and covered?
  • Any smell of damp or gas?
  • Note the date, time and anything found, and send a photo to the owner.

Agree in advance what the visitor should do if they find a leak: turn off the stop tap, switch off electrics near the water if safe, and call you. A visitor who knows where the stop tap is saves more damage than any gadget.

Example: a probate property

Example (fictional): an executor asks a firm in Worcester to protect a 1960s bungalow that will be empty from December until it is sold in spring. The insurer requires the water to be turned off and the system drained if nobody visits weekly. Nobody can, so the engineer carries out a full drain-down, labels the stop tap and boiler, photographs each drain point and sends the executor a one-page record. In April, before viewings start, the firm refills the system, finds and fixes a weeping compression joint, recommissions the boiler and runs every outlet. The executor forwards the record to the insurer and the estate agent.

Send occupied customers your frozen pipe prevention guide. For landlords with several homes, see pre-winter checks for landlord portfolios, and for what to do after storms and outages, power cuts and storms: heating system advice.

Frequently asked questions

Is it better to drain down an empty house or leave the heating on?

For short gaps with regular visits, a frost setting with outside taps isolated is usually enough. For long vacancies with no visits, or where the insurer requires it, a full drain-down is safer.

What temperature should the heating be set to in an empty house?

Use a low frost setting on the controls and make sure the boiler's frost protection is enabled. Check the owner's insurance, which may set its own minimum.

Do we need to worry about legionella when a property has been empty?

Yes. Water should not be allowed to stagnate; for long vacancies, flush outlets or drain the system[3], and run every outlet thoroughly on restart.

Can a landlord's gas safety check be done while the property is empty?

Yes, once the system is in normal working order. It must be done within 12 months of the last check[4], and the new tenant must get a copy before moving in.

References

  1. Ministry of Housing, Communities and Local Government (GOV.UK) (2024). English Housing Survey 2024 to 2025: Chapter 2, energy efficiency (opens in a new tab) ↑

  2. Ministry of Housing, Communities and Local Government (GOV.UK) (2024). English Housing Survey 2024 to 2025: Chapter 1, housing quality (opens in a new tab) ↑

  3. Health and Safety Executive (2026). Legionnaires' disease: landlords' responsibilities (opens in a new tab) ↑

  4. legislation.gov.uk (The National Archives) (1998). The Gas Safety (Installation and Use) Regulations 1998, regulation 36 (opens in a new tab) ↑

  5. legislation.gov.uk (The National Archives) (1998). The Gas Safety (Installation and Use) Regulations 1998, regulation 36 (opens in a new tab) ↑

Book a demo

See Ava handle your calls.

Book a short demo. We’ll walk through your calls and workflow, and agree what Ava should take care of.

Book a demo