Boilers heating

Smart thermostats and heating controls: advising customers

Match heating controls to the home and household: zoning, smart thermostats, compensation, what counts for Boiler Plus and how to set it up at handover.

Ava research teamPublished 6 min read

On this page
  1. Controls are where comfort complaints start
  2. What the guidance requires
  3. The main options
  4. Who actually uses connected controls
  5. Matching controls to the household
  6. Zoning without overcomplicating it
  7. Combis, cylinders and the hot water side
  8. Worked Example: same boiler, different controls
  9. Mistakes that cause control call-backs
  10. Handover: where controls succeed or fail
  11. Frequently asked questions
  12. References

Key takeaways

  • Start with how the household lives, then choose controls; the most capable thermostat is wasted on a customer who will never open the app.
  • When a boiler is replaced, every heated room needs thermostatic control, plus a boiler interlock and sensible time control[1].
  • A smart thermostat only counts as the Boiler Plus measure for a combi if it has automation and optimisation; TPI does not count as load compensation[2].
  • Only a minority of adults used internet-connected energy controls when the ONS last asked, so set expectations and hand over properly[3].

Controls are where comfort complaints start

A correctly sized boiler on a clean system can still produce a stream of complaints if the controls do not suit the people using them. Rooms too hot or too cold, hot water running out at the wrong time and heating that seems to come on by itself are usually control problems. Advising on controls is therefore part of the installation, not an accessory sale.

Begin with questions, not products. Who is at home and when? Which rooms are used and which sit empty? Does anyone work shifts or from home? Is there someone elderly or unwell who needs steady warmth? Will anyone actually use an app, and is the broadband reliable? The answers narrow the choice faster than any brochure.

What the guidance requires

Approved Document L sets a floor. When a boiler is replaced in an existing home, each heated room should have thermostatic room controls that can adjust output separately, either a room thermostat with thermostatic radiator valves elsewhere, individual room or zone thermostats, or networked emitter controls[1]. Adjacent rooms with similar use can be one zone, and a single-storey open-plan home where the living area dominates can be treated as one zone[1].

  • A boiler interlock whenever work is done on a system that includes a boiler[1].
  • Separate time control for heating and hot water, unless they were already controlled together by a single timer[1].
  • A cylinder thermostat or other electronic temperature control on any replacement cylinder[1].
  • For a gas combi in England, one Boiler Plus measure: flue gas heat recovery, weather compensation, load compensation or a smart thermostat with automation and optimisation[2].

The government's Boiler Plus guidance is specific about what 'smart' means for compliance: the device must offer load compensation, weather compensation, or automation combined with optimisation, and TPI controls are not load compensation[2]. Check the product's compliance statement rather than relying on its marketing.

The main options

Matching heating controls to households
ControlGood forLess good for
Programmable room thermostatHouseholds with regular routines who prefer buttons to appsHomes with very different use of rooms
Smart thermostat with automation and optimisationCustomers who want remote control and learning schedulesCustomers without reliable broadband or interest in apps
Smart radiator valves (room zoning)Homes with rooms used at different times, home officesVery small homes where one zone works fine
Weather compensationSteady, efficient heating with minimal user inputCustomers who want rapid warm-up from cold
Load compensation via boiler protocolGentler running with a compatible thermostatBoilers and thermostats that do not share a protocol

Combinations are common. A weather-compensated boiler with a simple programmable thermostat suits many older customers well; a learning smart thermostat with a few smart radiator valves can suit a busy family whose upstairs rooms sit empty all day.

Who actually uses connected controls

It is easy to assume everyone wants an app. When the ONS last measured it, in early 2020, 18% of adults in Great Britain used internet-connected energy or lighting controls, rising to 26% among those aged 35 to 44[3]. Use has grown since, but the point stands: a large share of your customers will rely on the wall unit, not the phone.

Adults in Great Britain using internet-connected energy or lighting controls, early 2020ONS internet access survey; use has grown since
Adults in Great Britain using internet-connected energy or lighting controls, early 2020Bar chart. All adults: 18%; Aged 35 to 44: 26%.All adultsAll adults: 18%18%Aged 35 to 44Aged 35 to 44: 26%26%Adults in Great Britain using internet-connected energy or lighting controls, early 2020Bar chart. All adults: 18%; Aged 35 to 44: 26%.All adultsAll adults: 18%18%Aged 35 to 44Aged 35 to 44: 26%26%

Source: Office for National Statistics, 2020[3]

Show the data
ItemValue
All adults18%
Aged 35 to 4426%

The same survey found 35% of adults used a smart speaker or voice assistant[3]. Voice control is a nice feature for some, but it should never be the only way to change the heating, especially for an older customer living alone.

Matching controls to the household

  • Older customer at home all day: steady heat, simple controls, weather compensation if available, large clear display. Avoid anything that needs an app to change a setting.
  • Working couple out all day: a smart thermostat with optimisation and a schedule, with hot water timed around their routine.
  • Family with a home office: zone the office with a smart radiator valve or separate zone so it can be heated without the whole house.
  • Rental property: robust controls that tenants understand, a thermostat that does not depend on the landlord's account, and frost protection.
  • Large house with rooms rarely used: smart radiator valves give the most benefit, but explain battery changes and pairing.

Zoning without overcomplicating it

Separate heating zones with their own thermostat and valve make sense where floors or areas are used at different times. For most homes, thermostatic radiator valves on every radiator except the one in the thermostat room do the job required by the guidance. Smart radiator valves add scheduling room by room, at the cost of batteries and setup.

Do not fit a thermostatic radiator valve in the same room as the room thermostat; the two fight each other and the boiler never sees the room as satisfied[1]. Leave at least one radiator or a bypass arrangement so the boiler has the minimum flow it needs.

Combis, cylinders and the hot water side

Controls advice usually focuses on space heating, but the hot water side matters just as much to the customer. With most English homes now on a condensing combi, 63% in 2024[4], there is often no hot water schedule to set at all, and the main decision is the hot water temperature on the boiler itself.

  • Combi homes: set the hot water temperature with the customer, explaining the trade-off between comfort, scale in hard water areas and efficiency.
  • Cylinder homes: set the cylinder thermostat and hot water schedule together, and explain why the cylinder must reach a safe storage temperature.
  • Homes with solar diverters or immersion timers: check the boiler schedule and the diverter do not fight each other.
  • Families with shift workers: a hot water boost button is often more useful than a complicated schedule.

Write the hot water settings on the same handover card as the heating schedule, so the customer has one place to look when something feels wrong.

Worked Example: same boiler, different controls

Example. A retired couple in a bungalow get a new combi. They do not use smartphones. The engineer fits a manufacturer weather sensor as the Boiler Plus measure, a simple programmable room thermostat in the lounge and standard thermostatic valves elsewhere. At handover the engineer writes the schedule on a card next to the thermostat.

Example. A family of four in a semi want to heat the loft office during the day without heating the bedrooms. The engineer fits a smart thermostat with automation and optimisation as the compliance measure, smart radiator valves in the office and bedrooms, and connects the app to the customer's own account. The engineer records the compliance functions enabled and the zone setup on the commissioning record.

Mistakes that cause control call-backs

  • Leaving the factory schedule in place, so the heating runs at times nobody is home and the customer assumes the boiler is faulty.
  • Siting the room thermostat in a hallway next to a radiator, in direct sun or above a cooker, so it reads a temperature unlike the rooms people use.
  • Pairing a thermostat to the installer's phone during setup and never transferring it.
  • Fitting smart radiator valves without explaining battery replacement, so they stop responding after a year.
  • Turning off compensation because the customer complained of slow warm-up once, without explaining the trade-off or adjusting the curve.

Most of these are avoided by ten unhurried minutes at handover and a follow-up call a week later asking whether the heating behaves as expected. That call is also the best moment to fix a schedule before it becomes a complaint.

Handover: where controls succeed or fail

  1. Set the schedule with the customer

    Use their actual routine, not the factory default, and show how to override it for a day.

  2. Set the temperatures

    Agree comfortable room temperatures and set the radiator valves to sensible positions.

  3. Enable the clever bits

    Turn on compensation or optimisation functions and confirm they are active in the boiler and thermostat menus.

  4. Connect accounts properly

    Register any app in the customer's name, never your own, and show them how to reset it.

  5. Explain frost protection and holidays

    Show how to set away mode without switching the boiler off entirely.

  6. Leave written notes

    A one-page summary of settings and how to change them saves a call-back.

Avoid promising a particular saving from any control. Say what the control does and how it helps the boiler run efficiently, and let the customer judge the benefit. See weather compensation explained and Boiler Plus requirements for more.

Frequently asked questions

Does any smart thermostat meet Boiler Plus?

No. For a combi in England it must provide automation with optimisation, or weather or load compensation. Check the product's compliance statement.

Do I need TRVs on every radiator?

Each heated room needs thermostatic control. Commonly that means TRVs on every radiator except in the room with the room thermostat.

Should the app be registered to the installer?

No. Register it in the customer's name so they control their own heating and data.

Are smart radiator valves worth it?

They help most in homes with rooms used at different times. In small homes with simple routines, standard TRVs and a good thermostat are often enough.

References

  1. Ministry of Housing, Communities and Local Government (GOV.UK) (2023). Approved Document L, Volume 1: Dwellings (2021 edition incorporating 2023 amendments) (opens in a new tab) ↑

  2. Department for Business, Energy and Industrial Strategy (GOV.UK) (2018). Boiler Plus: new standards for domestic boiler installations from April 2018, frequently asked questions (opens in a new tab) ↑

  3. Office for National Statistics (2020). Internet access - households and individuals, Great Britain: 2020 (opens in a new tab) ↑

  4. Ministry of Housing, Communities and Local Government (GOV.UK) (2024). English Housing Survey 2024 to 2025: Chapter 2, energy efficiency (opens in a new tab) ↑

Book a demo

See Ava handle your calls.

Book a short demo. We’ll walk through your calls and workflow, and agree what Ava should take care of.

Book a demo