Key takeaways
- The installed base is growing fast: 96,611 Boiler Upgrade Scheme installations had been paid out by the end of September 2026[1], and each one needs looking after.
- A heat pump service is a performance check as much as a safety check: filters, pressure, controls, flow temperatures and the hot water cycle.
- The first winter decides whether the customer becomes a fan or a complaint, so build a tuning visit into every install.
- Offer the plan at quote stage and sign it at handover; selling it later is much harder.
- Service reminders the customer asked for are part of the service, but promotional messages need consent or the soft opt-in[2].
Aftercare is where the long-term business is
Boiler firms have always known that the annual service list is worth more than any single installation. Heat pumps follow the same logic, with one difference: the customer is often less sure what good looks like, so your aftercare shapes how they judge the whole system. The installed base is building quickly. Up to the end of September 2026 there had been 160,874 Boiler Upgrade Scheme applications, 131,619 vouchers issued and 96,611 installations paid out[1].
Outside the grant scheme the numbers are larger again. Almost 100,000 hydronic heat pumps were sold in the UK in 2024[3], and MCS recorded 210,000 certified renewable installations in the first half of 2026 across all technologies[4]. Many of those systems were fitted by firms that do not want to service them, or that have since stopped trading. That is a second market for you: homeowners with a heat pump and nobody to call.
What a heat pump service should cover
Write your own service checklist and use it every time. Manufacturers set out what their warranty requires, so start there, then add the checks that catch performance problems early.
- Outdoor unit: clear leaves and debris, check the coil and fins, the fan, mounting and anti-vibration feet, and that condensate drains away freely and will not freeze into a path.
- Water side: system pressure, magnetic and strainer filters cleaned, inhibitor level tested, expansion vessel charge, and glycol concentration if the system uses it; check any anti-freeze valves.
- Controls: weather compensation curve, flow temperature limits, heating schedules and room thermostats, and whether the customer has changed anything since the last visit.
- Hot water: cylinder temperature, the scheduled high-temperature cycle, immersion operation, and the safety valves and discharge on unvented cylinders.
- Performance: read the heat and electricity meters or the controller's data, and compare with last year and with the design estimate.
- Refrigerant: visual checks for oil marks; formal leak checks where the charge is 5 tonnes CO2 equivalent or more and the kit is not exempt[5].
- Record: a dated service report the customer keeps, with readings, settings and any recommendations.
If you only check that the unit runs, you are doing a visit, not a service. The value is in the readings and the settings.
The first-year aftercare visits
Most heat pump complaints arrive in the first cold spell, when the customer notices the radiators feel cooler than the old boiler's or sees a higher bill than expected. Plan for it rather than reacting to it.
Two-week call
Phone the customer two weeks after handover. Ask about comfort, noise and hot water, and whether they have changed any settings.
First cold spell check
When the first sustained cold weather arrives, look at the controller data remotely if you can, or visit. Adjust the compensation curve if rooms are cool or the unit cycles.
End of first winter review
Compare the electricity used with the design estimate. Explain any gap honestly: weather, settings, occupancy or a fault.
First annual service
Do the full checklist, show the customer the year's readings and agree the plan for the next year.
These contacts cost a little time and save a lot. A customer who has been called before they had to call you is far more forgiving if something does need fixing.
Structuring an aftercare plan
Keep the plan simple enough to explain in a minute. Most firms settle on two or three levels, each with a clear list of what is included and what is not.
| Plan level (Example) | What it includes | Who it suits |
|---|---|---|
| Annual service | One full service a year with report and settings check | Customers who want the warranty kept valid |
| Service plus support | Annual service, first-winter tuning, priority booking for faults | Most new heat pump customers |
| Monitored | All of the above plus remote data review and alerts on faults or poor performance | Customers with remote monitoring and landlords |
Be careful about promising fixed response times you cannot keep in January. A plan that says priority booking and then leaves someone without heating for a week does more damage than having no plan. Write down what priority means: for example, a call back the same working day and a visit within a stated number of working days.
For landlords, there is a strong case for a combined service. HHIC and the EUA have called for the mandatory annual gas safety check in rented homes to be upgraded to a full service plus an efficiency check[6]; heat pumps in rented homes benefit from the same thinking, even though no annual gas check applies to them.
Costing a plan so it pays
Plans lose money when they are priced from a competitor’s leaflet rather than from your own costs. Work it out from the bottom up, then sense-check against the market.
- Engineer time on site for the full checklist, including the readings and the report, not just the clean.
- Travel time, which is larger for scattered rural customers than for a tight town patch.
- Consumables: filter cleaning, inhibitor top-ups, glycol testing and any seals routinely replaced.
- Office time for booking, reminders, renewals and chasing failed payments.
- A realistic allowance for the extra calls a plan customer makes, especially in the first winter.
Then decide what sits outside the plan: parts, refrigerant work, faults caused by third parties and work on systems that were never commissioned properly. Write the exclusions as plainly as the inclusions, because the dispute you avoid is usually about something the customer assumed was covered.
Building the recurring base
- Put the plan on the quote as a line the customer can tick, not as a separate leaflet.
- Explain it at handover with the first service date already booked in the diary.
- Send the customer a short summary of what the plan covers and how to report a fault.
- Remind them before each service, using the contact method they chose.
- Renew the plan automatically only if they agreed to that in writing, and remind them before renewal.
- Track renewals, cancellations and reasons every month; a rising cancellation rate is an early warning about service quality.
Reminders are where firms slip up with the rules. Under PECR, direct marketing emails and texts to individuals need prior consent, unless the soft opt-in applies to existing customers[2]. A reminder that a service the customer has bought is due is part of delivering that service. A message offering a new product is marketing, so keep the two separate and give an easy way to opt out of the second.
Winter puts the most pressure on the phones. If service bookings and fault calls arrive while engineers are on site, an AI Employee such as Ava can take the booking, capture the plan details and pass urgent faults to the on-call engineer, while you keep the plan rules in your own system.
Worked Example: a growing service list
Example (fictional): a firm fits 60 heat pumps a year and signs 70% of customers to a plan at handover. Each year roughly one in ten plan customers leave, mostly when they move house. After three years the firm has about 114 heat pump plan customers, plus the boiler service list it already had.
In the Example, the firm reserves one engineer for two days a week from April to September for heat pump services, which keeps winter capacity free for faults. It also takes on systems fitted by other installers, after a paid first visit to check the install and bring records up to date. That first visit is where it finds most of the settings problems behind its new customers' complaints.
Taking on heat pumps you didn't install
Orphaned systems are common and their owners are often frustrated. Before adding one to a plan, do a paid inspection visit: check the commissioning records, the design figures if they exist, the settings and the refrigerant type. Agree in writing that you are not responsible for design faults you did not create, and give the owner a list of what needs fixing before the system is covered. Our guide to performance monitoring explains the readings to take on that first visit, and design software helps when no design exists.
Frequently asked questions
How often should a heat pump be serviced?
Follow the manufacturer's warranty terms, which usually require an annual service. A first-winter tuning visit is worth adding for new installs.
What does a heat pump service include?
Outdoor unit cleaning and condensate checks, filters, pressure, inhibitor and glycol, controls and compensation curve, the hot water cycle, meter readings and any refrigerant checks the charge requires[5].
Can I send service reminders by text?
Reminders about a service the customer has bought are part of the service. Promotional texts and emails to individuals need prior consent or the soft opt-in[2].
Should I service heat pumps another firm installed?
Yes, after a paid inspection visit to check records, settings and refrigerant, with a written note of anything that must be fixed before cover starts.
References
Department for Energy Security and Net Zero (2026). Boiler Upgrade Scheme (BUS) monthly statistics: England and Wales, September 2026 (opens in a new tab) ↑
legislation.gov.uk (The National Archives) (2003). The Privacy and Electronic Communications (EC Directive) Regulations 2003, regulation 22 (opens in a new tab) ↑
Heating and Hotwater Industry Council (HHIC) (2024). Bumper year for UK heat pumps (opens in a new tab) ↑
MCS (Microgeneration Certification Scheme) (2026). Record number of UK households combining renewables to improve energy resilience (20 August 2026) (opens in a new tab) ↑
legislation.gov.uk (The National Archives) (2014). Regulation (EU) No 517/2014 on fluorinated greenhouse gases, Article 4: Leak checks (as retained in UK law) (opens in a new tab) ↑
Heating and Hotwater Industry Council (HHIC) (2025). Call to enhance Gas Safety Checks (opens in a new tab) ↑