Seasonal operations

After a flood: plumbing and heating recovery work

Flood recovery for heating firms: safety checks before reconnection, what to replace, working with insurers, building regs and resilient refits.

Ava research teamPublished 7 min read

On this page
  1. Flooding is a heating job too
  2. First visit: safety before anything else
  3. What usually needs replacing
  4. Working with insurers and loss adjusters
  5. Building regulations after a flood
  6. Hygiene and contaminated water
  7. Drying out and running the heating
  8. Resilient reinstatement
  9. Pricing, payment and paperwork
  10. When several streets flood at once
  11. Example: a ground-floor flood
  12. Related reading
  13. Frequently asked questions
  14. References

Key takeaways

  • About 6.3 million properties in England are in areas at risk of flooding[1], so flood recovery is a regular job for many heating firms, not a rare one.
  • Nothing gets switched back on until it is checked: official guidance says not to turn on water, gas or electricity until a utility company or qualified engineer confirms it is safe[2].
  • Photograph and record everything before stripping out, and do not dispose of equipment until the insurer agrees[2].
  • Emergency boiler repairs need no advance building regulations approval, but replacing a heating system can[3][4].
  • Offer resilient reinstatement: higher boilers and controls, sealed connections and an isolation plan for the next flood.

Flooding is a heating job too

After a flood, homeowners call the insurer, the electrician and the plumber, often on the same morning. Floodwater damages boilers, controls, pumps, cylinders and pipe insulation, and contaminated water gets into everything below the waterline. For firms in flood-prone areas, this is predictable work that needs a clear process.

The scale is significant. The Environment Agency's 2024 national assessment found 6.3 million properties in England in areas at risk of flooding. Around 4.6 million are at risk from surface water and around 2.4 million from rivers and the sea, and the total could rise to around 8 million by the middle of the century[1]. Some properties face both, so the two groups overlap.

Properties in England in areas at risk of flooding, by source, 2024Some properties are at risk from both sources; the overall total is 6.3 million
Properties in England in areas at risk of flooding, by source, 2024Bar chart. Surface water: 4.6 million properties; Rivers and the sea: 2.4 million properties.Surface waterSurface water: 4.6 million properties4.6 million propertiesRivers and the seaRivers and the sea: 2.4 million properties2.4 million propertiesProperties in England in areas at risk of flooding, by source, 2024Bar chart. Surface water: 4.6 million properties; Rivers and the sea: 2.4 million properties.Surface waterSurface water: 4.6 million properties4.6 million propertiesRivers and the seaRivers and the sea: 2.4 million properties2.4 million properties

Source: Environment Agency (GOV.UK), 2024[1]

Show the data
ItemValue
Surface water4.6 million properties
Rivers and the sea2.4 million properties

First visit: safety before anything else

Government guidance tells householders not to turn on their water, gas or electricity after a flood, and to get the utility company or a qualified engineer to check they are safe first[2]. Your first visit is that check for the heating and water side.

  1. Confirm electrics are isolated

    Do not start until the electrical supply to affected areas is off and an electrician has been or is booked. Treat any boiler, pump or control that was under water as live until proven otherwise.

  2. Check the gas installation

    Floodwater can enter gas pipework and meters. Work on gas fittings is restricted by law to approved persons, in practice the Gas Safe Register[5]. Test for tightness and check appliances before any are used.

  3. Inspect flues and ventilation

    Debris and silt can block low-level flues and air vents. Check terminals and combustion air paths.

  4. Assess the water supply

    Check for damaged pipework and fittings and whether contaminated water may have entered the system. Flush outlets thoroughly before use.

  5. Record everything

    Photograph the flood line, each appliance and its data plate, and anything you remove. Note what was under water and for roughly how long.

If anyone reports headaches, dizziness or nausea after using a flood-affected appliance, stop it at once: the NHS advises anyone who suspects carbon monoxide poisoning to stop using the appliance and get medical advice[6].

What usually needs replacing

Manufacturers' guidance should decide each case, and many say that a boiler or control unit that has been submerged must be replaced rather than dried out. In practice the decisions follow a pattern.

Typical outcomes for heating and plumbing equipment after floodwater, subject to manufacturer guidance
EquipmentIf submergedUsual outcome
Wall-hung boiler above the flood lineNot submerged, but check flue and gas supplyService and test before use
Boiler or controls submergedWater in electronics, burner and gas valveReplace
Circulating pump and motorised valvesWater in motors and wiringReplace
Hot water cylinderDepends on type, insulation and controlsAssess; unvented cylinders and their controls often replaced
Radiators and copper pipeworkExterior contaminationUsually cleaned, flushed and reused
Pipe insulation and underfloor insulationHolds contaminated waterRemove and replace
Underfloor heating manifold and actuatorsElectrical parts damagedReplace actuators and wiring centre; assess pipework

Working with insurers and loss adjusters

The customer's first call should be to their insurer, who will explain what happens next. Guidance also tells householders to photograph damage and the flood water line, and to ask the insurer what they can move and throw away[2]. Make that easy for them.

  • Give the customer a written report: what was affected, what you found and what you recommend, with photos and model numbers.
  • Itemise quotes: like-for-like replacement first, then any upgrades listed separately so the insurer can see what is betterment.
  • Keep removed equipment until the customer confirms the insurer or loss adjuster does not need to see it.
  • Find out early whether the insurer will use its own contractors or let the customer choose; it affects who pays you and when.
  • Agree in writing who you are invoicing and when payment is due, because insurer timescales can be long.

Building regulations after a flood

Emergency repairs to a boiler or heating system do not need advance building regulations approval, though the rules still apply[3]. A full replacement of a heating system, or adding radiators, can need approval[4]. If you are registered with a competent person scheme, you can self-certify the work and the homeowner does not need to apply separately[7]. Make sure notifications are made, because insurers and future buyers will ask for them.

Hygiene and contaminated water

Floodwater often contains sewage, chemicals and debris. Wear gloves, eye protection and suitable footwear; cover cuts; wash hands before eating; and clean tools before using them on the next job. Flush the cold and hot water services through all outlets before the customer uses them, and advise them to follow any boil-water or supply notices from their water company.

Drying out and running the heating

Customers want the heating back on to dry the house. Once the system has been checked and is safe, gentle heating with good ventilation helps drying, but follow the drying contractor's plan where there is one, because too much heat too fast can damage plaster and timber. Damp is already a problem in 5% of homes in England[8], and flood-damaged homes are at much higher risk of lasting damp and mould.

Resilient reinstatement

If a home has flooded once, it may flood again. Talk to the customer and the insurer about reinstating in a way that limits damage next time. Some insurers will contribute to resilience measures; others pay only like-for-like.

  • Mount the boiler, controls and wiring centre above the likely flood level, ideally on an upper floor.
  • Use closed-cell pipe insulation that does not hold water.
  • Fit isolation valves so the ground floor can be isolated quickly.
  • Label stop taps and isolation points clearly and show the customer how to use them.
  • Consider wall-mounted rather than floor-standing equipment where space allows.

Pricing, payment and paperwork

Flood work is often paid by an insurer weeks after the job, and the customer may be living elsewhere in the meantime. Protect your cash flow without making a difficult time harder for the customer. Agree in writing who will pay, what happens if the insurer pays only part, and whether you need a deposit for equipment you order. If the insurer appoints its own contractors, find out early whether you are one of them or whether the customer is free to choose.

  • Keep a separate job file for each flood job: photos, reports, quotes, approvals and invoices.
  • Send the report and quote to the customer and, with their permission, the loss adjuster.
  • Do not start replacement work until the scope is approved, unless it is an emergency repair needed to make the home safe or habitable.
  • Record any emergency work separately, with the reason it could not wait.

When several streets flood at once

A major flood can bring dozens of calls in a day. Triage them the same way you would in a cold snap: first, anyone without heat who is at higher risk from cold and anyone with a suspected gas or carbon monoxide problem; second, homes that are occupied and need heating to dry out; third, empty homes where owners are living elsewhere. Keep a single list of every enquiry and be honest about waiting times. Customers who know they are tenth on a list are more patient than those who hear nothing.

Example: a ground-floor flood

Example (fictional): a terraced house in York takes 40cm of river water for a day. The firm's engineer visits the next morning after an electrician has isolated the ground floor. The wall-hung combi in the kitchen sits above the water line, but the wiring centre for the underfloor heating and the pump were submerged. The engineer tests the gas installation, checks the flue, photographs everything and writes a report for the insurer with a like-for-like quote and a separate option to move the wiring centre upstairs. Removed parts are bagged and labelled. The loss adjuster approves both, and the system is back in use within two weeks.

For storm-related outages, see power cuts and storms: heating system advice. Insurance work affects cash flow, so read January cash flow. For burst pipes rather than floods, see escape of water insurance claims.

Frequently asked questions

Can a flooded boiler be dried out and reused?

Usually not if it was submerged. Follow the manufacturer's guidance, which for many boilers and controls is to replace them. A boiler above the water line still needs its gas supply and flue checked.

Who should turn the gas back on after a flood?

A Gas Safe registered engineer, after checking the installation. Householders are told not to turn utilities back on until they have been checked[2].

Do we need building regulations approval to replace a flooded boiler?

Emergency repairs do not need advance approval, though the rules apply[3]. Replacing a heating system can need approval, which a competent person scheme member can self-certify[7].

Should we throw away flood-damaged parts?

Not until the customer confirms with their insurer. Guidance advises asking the insurer what can be moved and thrown away[2].

References

  1. Environment Agency (GOV.UK) (2024). Environment Agency publishes major update to national flood and coastal erosion risk assessment (opens in a new tab) ↑

  2. GOV.UK (2026). What to do after a flood (opens in a new tab) ↑

  3. GOV.UK (2026). Building regulations approval (opens in a new tab) ↑

  4. GOV.UK (2026). Building regulations approval (opens in a new tab) ↑

  5. legislation.gov.uk (The National Archives) (1998). The Gas Safety (Installation and Use) Regulations 1998, regulation 3 (opens in a new tab) ↑

  6. NHS (2026). Carbon monoxide poisoning (opens in a new tab) ↑

  7. GOV.UK (2026). Building regulations approval (opens in a new tab) ↑

  8. Ministry of Housing, Communities and Local Government (GOV.UK) (2024). English Housing Survey 2024 to 2025: Chapter 1, housing quality (opens in a new tab) ↑

Book a demo

See Ava handle your calls.

Book a short demo. We’ll walk through your calls and workflow, and agree what Ava should take care of.

Book a demo