Boilers heating

Registering boiler warranties: a checklist for installers

A close-out checklist for boiler warranty registration: deadlines, filter and service conditions, building regulations notice and the customer's copy.

Ava research teamPublished 6 min read

On this page
  1. Three registrations, three deadlines
  2. The close-out checklist
  3. Conditions that most often void cover
  4. Why the paper trail matters more than it seems
  5. Worked Example: a registration that nearly lapsed
  6. Special cases that trip installers up
  7. The customer's copy: what to leave behind
  8. Making it routine in the office
  9. Frequently asked questions
  10. References

Key takeaways

  • Warranty registration, building regulations notification and the commissioning record are three separate tasks with their own deadlines; close all three on every job.
  • The law gives you 30 days after completion to give the occupier their building regulations certificate and notify building control[1].
  • Most warranty conditions hinge on water treatment, a filter and annual servicing, so record them at commissioning[2].
  • Consumer problems with home repair and maintenance services are common enough that a clean paper trail is worth the ten minutes it takes[3].

Three registrations, three deadlines

When an installer says a boiler is 'registered' they can mean three different things, and customers often assume all three happened. Mixing them up is how warranties lapse and how a house sale stalls years later because a certificate cannot be found.

  • Building regulations notification: the legal step. Through a competent person scheme you must, within 30 days of completing the work, give the occupier a copy of the certificate and give building control a notice or the certificate[1].
  • Commissioning record: the evidence that the system was cleaned, treated and set up properly. Approved Document L notes that the Benchmark checklist can be used to show commissioning was done satisfactorily[2].
  • Manufacturer warranty registration: the commercial step that activates the cover the customer was quoted, with whatever deadline the manufacturer sets.

Treat each one as a separate line on your close-out sheet with its own tick, date and initials. The office should be able to see at a glance which of the three are still open for any job.

The close-out checklist

  1. Confirm the warranty you quoted

    Check the quote for the warranty length and conditions so you register the right level of cover, especially if you belong to a manufacturer scheme.

  2. Photograph the evidence

    Take clear photos of the data badge with serial number, the filter, the controls, the flue terminal, the condensate route and the inhibitor bottle or dosing record.

  3. Complete the commissioning record

    Record combustion readings, gas rate, system cleaning method, inhibitor product, filter type, scale protection and controls fitted. The cleaning and inhibitor steps are part of commissioning to BS 7593[2].

  4. Register with the manufacturer

    Use the serial number from the badge, not the box, and the customer's correct address and contact details. Note the confirmation reference.

  5. Notify the work

    Submit the building regulations notification through your competent person scheme so the certificate reaches the occupier within the 30-day limit[1].

  6. Hand over the customer's copies

    Leave or send the user instructions, the commissioning record access details and the warranty conditions in writing.

  7. Diary the first service

    Book or schedule a reminder for the first annual service, because many warranties need it to stay valid.

  8. Close the job

    Only mark the job complete when all three registrations show a confirmation reference.

Conditions that most often void cover

Warranty conditions to check before signing off an install
ConditionWhat usually goes wrongHow to prevent it
Registration deadlinePaperwork left until month end and forgottenRegister before leaving site or same day from the office
Annual serviceCustomer skips a year or uses an unrecorded engineerSend reminders; record every service on the commissioning log
System filterFilter not fitted or a different brand than the scheme requiresCheck scheme rules at quote stage
Water treatmentNo record of cleaning or inhibitorWrite the method and product on the record and photograph it
Scale protectionMissing in a hard water areaCheck hardness on the survey
Correct installationFlue or condensate not to instructionsCommissioning checklist and photos

Approved Document L expects circuits to be thoroughly cleaned and flushed before a new heating appliance goes in, inhibitor to be added, hard water to be treated and systems to be commissioned to BS 7593[2]. Manufacturers' warranty terms usually echo those expectations, which is why a thin commissioning record is the first thing a warranty assessor queries.

Why the paper trail matters more than it seems

Disputes over home repair work are not rare. In the government's consumer protection study, 25% of UK adults had bought home and garden maintenance and repair services, which include plumbing and central heating, in the previous year, and 11% of those buyers had a consumer problem[3].

Buyers of home maintenance and repair services who had a consumer problemUK adults who bought these services in the 12 months to April 2021
Buyers of home maintenance and repair services who had a consumer problemDonut chart. Had a consumer problem: 11%.Had a consumer problem: 11%11%
  • Had a consumer problem 11%

Source: Department for Business, Energy and Industrial Strategy (GOV.UK), 2021[3]

Show the data
ItemValue
Had a consumer problem11%

When a boiler fails under warranty, the first question is usually whether it was installed and maintained according to the instructions. Photos, a complete commissioning record and a registration confirmation answer that question in minutes. Without them you may end up attending at your own expense to prove a point the paperwork could have proved for you. Your duty to work with reasonable care and skill applies either way[4].

Worked Example: a registration that nearly lapsed

Example. A heating firm fits a combi in late November. The engineer completes the commissioning record on site but leaves the manufacturer registration for the office. The office is busy with breakdowns and the registration slips. Three months later the boiler shows a fan fault and the manufacturer has no record of the installation.

Example. Because the engineer photographed the data badge and the commissioning record shows the install date, the firm can contact the manufacturer, explain the error and ask for the registration to be accepted late. Whether the manufacturer agrees is at its discretion. The firm changes its process so the engineer registers from the van before leaving site, and the office checks a weekly list of jobs with any registration still open.

Special cases that trip installers up

Most registrations are routine. A handful of situations come up often enough to deserve a written rule in your office procedures, because they are where cover is most often lost or the wrong person ends up holding the paperwork.

  • Landlord properties: register the warranty in the owner's name with the managing agent's contact as secondary, and tell the landlord in writing that the annual gas safety check is not the same as the warranty service.
  • Tenanted homes where the occupier is not the owner: the regulations require the certificate to go to the occupier[1], so make sure the owner also receives a copy through you.
  • Boilers supplied by the customer: check where it was bought and whether the manufacturer will honour the full warranty on a customer-supplied appliance before you agree to fit it.
  • Homes being sold soon after the install: hand the seller everything the buyer's conveyancer will ask for, including the certificate and the commissioning record access details.
  • Replacement under warranty: when a manufacturer replaces a boiler, confirm how the warranty period is treated and update your own records with the new serial number.
  • Second fix by another firm: if someone else commissions a boiler you installed, agree in writing who registers it before work starts.

Write the rule for each case on one page and keep it where the office and engineers can find it. New starters pick up the habit from the page rather than from the first mistake.

Keep the commissioning record digital where you can. The paper Benchmark checklist is no longer maintained and the record has moved online and to apps[5], which also means the customer, the manufacturer and any later engineer can see the same history instead of relying on a booklet left in a cupboard.

The customer's copy: what to leave behind

Customers lose paper, so give them the essentials in a form they will keep. An email at handover, with the key documents attached or linked, is easier to find later than a folder in a kitchen drawer.

  • User instructions for the boiler and controls.
  • How to access the commissioning and service record.
  • The manufacturer registration confirmation and the warranty conditions in plain words.
  • When to expect the building regulations certificate and what to do if it does not arrive.
  • Your contact details for workmanship issues, and the manufacturer's for warranty breakdowns.
  • A note of when the first service is due.

Ask the customer to reply to your handover email if the building regulations certificate has not arrived after a few weeks. It turns a problem you would hear about at house sale into one you fix while the job is fresh.

Making it routine in the office

In small firms registration usually fails because it belongs to nobody. Assign each step to a named person and give it a deadline that sits well inside the legal and manufacturer limits. A shared job board with three columns for notification, commissioning record and manufacturer registration is enough for most firms.

Review the open items every week. Any job approaching day 20 with the notification still open should be chased the same day, because the 30-day limit in the regulations is not flexible[1].

If you belong to a manufacturer scheme, its terms may impose a shorter registration deadline than the brand's standard warranty. See manufacturer installer schemes and completing the Benchmark checklist for the detail.

Frequently asked questions

Is warranty registration the same as Gas Safe notification?

No. Notification is the legal building regulations step through your competent person scheme. Warranty registration is a separate commercial step with the manufacturer. Do both.

How long do I have to notify a boiler installation?

The Building Regulations require the certificate to be given to the occupier, and building control notified, not more than 30 days after the work is completed.

What if a registration is missed?

Contact the manufacturer straight away with the serial number, install date and commissioning record. Accepting a late registration is at its discretion, so fix the process to prevent a repeat.

Who should keep the commissioning record?

The record belongs with the appliance and the customer. Leave access details with the customer and keep your own copy with the job file.

References

  1. legislation.gov.uk (The National Archives) (2010). The Building Regulations 2010, regulation 20 (opens in a new tab) ↑

  2. Ministry of Housing, Communities and Local Government (GOV.UK) (2023). Approved Document L, Volume 1: Dwellings (2021 edition incorporating 2023 amendments) (opens in a new tab) ↑

  3. Department for Business, Energy and Industrial Strategy (GOV.UK) (2021). Consumer protection study 2022: understanding the impacts and resolution of consumer problems (opens in a new tab) ↑

  4. legislation.gov.uk (The National Archives) (2015). Consumer Rights Act 2015, section 49 (opens in a new tab) ↑

  5. Heating and Hotwater Industry Council (HHIC) (2026). Benchmark goes digital - what homeowners need to know (opens in a new tab) ↑

Book a demo

See Ava handle your calls.

Book a short demo. We’ll walk through your calls and workflow, and agree what Ava should take care of.

Book a demo