Phones call handling

Talking a caller through a leak before you arrive

A phone script for leak calls: finding the stop tap, keeping clear of electrics, switching off the boiler and limiting damage while the engineer travels.

Ava research teamPublished 7 min read

On this page
  1. The first ten minutes matter more than the repair
  2. Priorities, in order
  3. The script
  4. When the stop tap will not turn or cannot be found
  5. Keeping the caller calm while they wait
  6. What to capture for the engineer
  7. Leaks, damp and rented homes
  8. Prevention advice worth giving after the job
  9. Example: a ceiling leak at teatime
  10. Frequently asked questions
  11. References

Key takeaways

  • People first: if water is near electrics, the caller must not touch them and should switch off at the fuse box if it is safe to reach[1].
  • The stop tap is usually under the kitchen sink but can be elsewhere, even outside[2].
  • After turning off the water, switch off the boiler or immersion heater and open the taps to drain the system[2].
  • Ask for photos and capture the details the engineer needs, so the van leaves with the right parts.
  • Leaks that become damp are a growing problem in housing, and significant leaks are emergency hazards for social landlords[3][4].

The first ten minutes matter more than the repair

Most of the damage from a leak happens before the plumber arrives. Water through a ceiling, a split pipe under the stairs or a failed washing machine hose can soak floors, plaster and electrics in minutes. If the person on the phone can get the caller to turn off the water and keep away from electrics, the job when the engineer arrives is a repair, not a restoration. A calm, well-ordered phone script is one of the most valuable things a plumbing firm can have.

The person taking the call does not need to be a plumber. They need to know the order of priorities, the right words for each step and when to stop giving advice and simply get someone there.

Priorities, in order

  1. Safety: keep away from water near electrics, sockets and light fittings, and away from a sagging ceiling.
  2. Stop the water: turn off the stop tap.
  3. Take heat off the system: switch off the boiler or immersion heater.
  4. Drain and contain: open taps to empty the pipes, then use buckets and towels.
  5. Record and report: photos for the engineer and for the insurer.

Stick to this order even if the caller wants to start with the mopping. A towel on the floor achieves nothing while water is still running, and nothing is worth touching a wet socket for.

The script

  1. Check for electrics

    "Is the water anywhere near sockets, switches, lights or electrical appliances? If it is, please don't touch them. If you can reach your fuse box safely without walking through water, switch the electricity off there."

  2. Find the stop tap

    "Do you know where your stop tap is? It's usually under the kitchen sink, but it can be in a downstairs cupboard, under the stairs, in the garage or sometimes outside."

  3. Turn it off

    "Turn it clockwise until it stops. If it's stiff, use a cloth for grip, but don't force it so hard it snaps."

  4. Boiler off

    "Now please switch off your boiler, or your immersion heater if you have a hot water tank."

  5. Drain the pipes

    "Turn on the taps in the house to let the water in the pipes run away. That takes pressure off the leak."

  6. Contain

    "Put a bucket or bowl under the drip, use towels on the floor, and move anything valuable out of the way. Stay out from under a ceiling that's sagging."

  7. Photograph

    "When it's safe, take a few photos of where the water's coming from and send them to us. They also help with your insurance."

The steps follow consumer and weather-service guidance. CCW, the water consumer body, advises turning off the water at the stop tap, making sure the central heating boiler or immersion heater is off, turning on the taps to reduce flooding, and contacting the insurer with photos or videos of the damage[2]. The Met Office adds that if water has leaked near electrics, people should not touch them and should switch them off at the fuse box, and suggests soaking up escaping water with towels[1].

When the stop tap will not turn or cannot be found

Every supply pipe serving separate premises must have a stopvalve conveniently located to allow the supply to be shut off[5], but that does not mean the caller can find it or that it still works. Old stop taps seize, some are hidden behind kitchen units fitted years after the pipework, and some flats share a valve in a communal area.

  • Ask about other likely places: under the stairs, a downstairs toilet, the garage, a utility room or a cupboard where the water pipe enters the house.
  • For flats, ask whether there is a caretaker, a managing agent's out-of-hours line or a communal riser cupboard.
  • If there is a cold-water storage tank in the loft, a gate valve on its outlet may stop water feeding part of the system; only suggest it if access is safe.
  • Outside stop taps, usually under a small cover near the boundary, normally belong to the water company or need a special key; if the caller cannot isolate inside, suggest they contact their water company as well as waiting for you.

If the water cannot be stopped at all, upgrade the call. The engineer should leave now if possible, and the caller should focus on safety and containment while they wait.

Keeping the caller calm while they wait

Once the water is off, the caller's adrenaline usually turns into worry: about the ceiling, the cost, the insurance and how long you will be. The way you end the call shapes how the rest of the job goes. Give a realistic arrival time rather than an optimistic one, and tell them what to do if things change before the engineer gets there.

  • Give an honest arrival window and say you will ring if it changes.
  • Tell them to call back straight away if water starts again, the ceiling sags further or anything electrical trips.
  • Suggest they keep the stop tap off, even if the drip stops, until the engineer has looked.
  • Remind them to photograph the damage and contact their insurer when they have a moment, not now.

If the caller is elderly, alone or clearly distressed, note it and consider ringing back after ten minutes to check they are coping. A short call costs nothing and it is often what the customer remembers most about the job.

What to capture for the engineer

Leak call details that help the engineer bring the right parts
DetailWhy the engineer needs it
Where the water is coming fromPipe, fitting, appliance, cylinder, tank or roof
Whether the water is stoppedSets priority; uncontrolled leaks go first
Pipe material if visibleCopper, plastic or lead changes the fittings needed
Hot or coldHot water leaks point to cylinder or heating circuits
Water near electricsSafety on arrival; may need an electrician too
Ceiling or floor damageAccess and protection needed
PhotosDiagnosis and parts before arrival
Landlord or agent detailsWho authorises and pays

Leaks, damp and rented homes

Leaks that are not fixed promptly turn into damp. The English Housing Survey found that 5% of dwellings in England, about 1.4 million homes, had a damp problem in 2024, up from 4% in 2021 and 2022[3]. Slow leaks behind baths, under floors and around cylinders are a common contributor, and they are often reported first as a stain or a smell rather than running water.

Dwellings in England with a damp problemEnglish Housing Survey; 2024 equals about 1.4 million dwellings
Dwellings in England with a damp problemColumn chart. 2021: 4%; 2022: 4%; 2024: 5%.0%2%4%6%2021: 4%4%20212022: 4%4%20222024: 5%5%2024Dwellings in England with a damp problemColumn chart. 2021: 4%; 2022: 4%; 2024: 5%.0%2%4%6%2021: 4%4%20212022: 4%4%20222024: 5%5%2024

Source: Ministry of Housing, Communities and Local Government (GOV.UK), 2024[3]

Show the data
ItemValue
20214%
20224%
20245%

Firms working for social landlords in England should know how Awaab's Law treats leaks. Government guidance lists significant leaks, total loss of water supply, broken boilers and gas or carbon monoxide leaks among the examples of emergency hazards[4]. Landlords must investigate emergency hazards and carry out the necessary safety work quickly, so a leak call from a social housing tenant may come with a contractual response time that is much tighter than your usual one. Check the contract and route those calls accordingly.

Prevention advice worth giving after the job

Once the leak is fixed, a minute of advice prevents the next panic call. The Met Office recommends making sure you know where your stop tap is and checking it works every six months[1]. Engineers can show the customer the stop tap, check it turns, label it, and fit a new one if it is seized. For landlords, suggest putting the stop tap location in the tenant welcome pack.

Example: a ceiling leak at teatime

Example: a fictional caller rings at 5.30pm because water is dripping through the kitchen light fitting from the bathroom above. The office manager tells him not to touch the light switch and to switch off the lighting circuit at the fuse board, which is in the hallway, away from the water. They find the stop tap under the sink together, turn it off, switch off the combi boiler and open the kitchen cold tap. He puts a bucket under the drip and sends three photos showing a wet floor around the bath panel. The engineer arrives at 6.40pm with a bath waste kit and silicone, having already guessed from the photos that it was the waste, not a supply pipe. The repair takes an hour and the ceiling dries out.

Keep the leak script on a card by every phone that takes customer calls. In an emergency, people read, they do not remember.

Frequently asked questions

Where is the stopcock usually found?

Most often under the kitchen sink, but it can be under the stairs, in a downstairs toilet, a garage, a utility room or outside. In flats it may be in a communal cupboard.

Should a caller turn on the taps after turning off the water?

Yes. Once the stop tap is off and the boiler or immersion heater is switched off, opening the taps drains water from the pipes and reduces pressure on the leak.

What if water is coming through a light fitting?

Do not touch the light switch or fitting. If the fuse board can be reached safely, switch off the electricity there, then turn off the water and keep out from under the ceiling.

References

  1. Met Office (2026). What to do if you have a frozen or burst pipe (opens in a new tab) ↑

  2. CCW (Consumer Council for Water) (2026). Winter advice (opens in a new tab) ↑

  3. Ministry of Housing, Communities and Local Government (GOV.UK) (2024). English Housing Survey 2024 to 2025: Chapter 1, housing quality (opens in a new tab) ↑

  4. Ministry of Housing, Communities and Local Government (GOV.UK) (2026). Awaab's Law: Guidance for social landlords - Timeframes for repairs in the social rented sector (opens in a new tab) ↑

  5. legislation.gov.uk (The National Archives) (1999). The Water Supply (Water Fittings) Regulations 1999, Schedule 2 (opens in a new tab) ↑

Book a demo

See Ava handle your calls.

Book a short demo. We’ll walk through your calls and workflow, and agree what Ava should take care of.

Book a demo